+62-21-344 2919      +62-21-3511 428      +62-811-9119-611   
    deltacrete@gmail.com      Senin - Jumat 9.00 - 17.00

Deltabond PVA

Multi Purpose Polymer Bonding Agent


General purpose PVA adhesive for concrete and mortar based on polymerised resins, white milky, water based emulsion of medium viscosity, which dries to a transparent film.


Bonding agent for concrete, mortar and ceramic tile.


  • Increases adhesion in cementitious mixes
  • Giving better workability
  • Easy to dilute and apply
  • Reduces porosity and cracking in cement mortar.


Added to the mixing water within the range 1:1 to 1:3, depending on type of application.


The substrate must be sound, clean and free of dust and loose particles.

All cement laitance, oil, grease, dirt, etc. must be removed by using wire brush or other method.


Bonding of new concrete to old concrete

All the old concrete surfaces should be saturated with water.

Apply bonding coat by mixing cement with solution of 1 part of Deltabond PVA and 1 part of water, into a slurry consistency, and then lay the new concrete while the bonding is still tacky.

As a cement mortar rendering

Seal the surface and prime with slurry of solution of Deltabond PVA and water of 1:1 mixed with cement.

Then plaster or render while the bonding still tacky.

Suggested mixes for:

Rendering for rough coat (thickness 10-30 mm)

Mix cement and clean sand of 1:3 proportions, gauged to a stiff consistency with Deltabond PVA and water of 1:1 proportion solution.


Rendering for finishing coat (thickness 0-3 mm)

Mix cement with solution of Deltabond PVA and water of 1:1 proportions, to a trowelable consistency

As a bonding agent for ceramic tile

Dampen the substrate as well as the tiles.

Apply a solution of Deltabond PVA and water of 1:2 proportions to the damp substrate and to the back of the tiles and allow to become tacky, then plaster the tile with mortar which has been treated with Deltabond PVA as the required thickness above and firmly press to the floor or wall to ensure full contact.


Do not use Deltabond PVA as bonding coat without adding cement.

Avoid contact with skin or eyes; any contamination should be washed immediately with plenty of water.

Gloves and protective clothing are recommended.


Type Polyvinyl Acetate Emulsion
Colour White
Specific Gravity 1,035 kg/litre
Shelf Life 1 year when unopened
Packaging 50 kg can


Deltabond PVA is a water-based PVA material, and during use, avoids inhalation contact with the skin or eyes. Wear suitable protective clothing - eye protection, gloves and respiratory equipment, particularly in confined spaces. In case of contact with the skin, rinse with plenty of clean water, then cleanse thoroughly with soap and water. In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice. If swallowed seek medical attention immediately.


Deltabond PVA is a water-based PVA material and is a non-flammable.

Our Location

PT. Deltacretindo Wira Mandiri
  JL. Pintu Air IV No. 41A
  Jakarta, Indonesia 10710
  +62-21-344 2919
  +62-21-3511 428
   :  deltacrete@gmail.com

haki cm

© 2017 Deltacretindo. All Rights Reserved. Powered By GM-Portalindo