Epoxy Mortar for Repair Adhesive
DESCRIPTION
Deltafix EP is two packed Epoxy Resin and Hardener with certain dosage in paste form, used for repair and adhesion between mortar.
USES
Deltafix EP is suitable for adhesion material of building structure including pre-melding mortar.
ADVANTAGES
- Formulated for use in hot climates
- Easy to mix and apply
- Excellent bond to the concrete substrate
- Thyrotrophic : non-sag in vertical and overhead application
- Solvent free
- No Shrinkage
- Suitable for dry and damp substrate
APPLICATION INSTUCTION
Preparation
Substrate must be sound, dry, clear, and contaminant free. Clean the surface and remove any dust, grease, oil and any loose materials. Oil and grease deposits should be removed by steam cleaning.
Mixing
Mixing Ratio: Component A : Component B = 1.45 :1
Mix components A + B together for at least 3 minutes, until the material becomes smooth and create a uniform grey colour. This ration of mixing should not be varied, and should be finished use within its pot life. The mixing will reach pot live in 25 minutes.
Application
Apply the mixed Deltafix EP to the prepared substrate by gloved hand or trowel.
Thoroughly compact the mortar or the substrate and attach the other mortar, make sure the both surface contacted properly.
Finishing
Clean and tidy the application.
Curing
This epoxy mortar will be cured in 1 day and full cured in 7 days.
Cleaning
Deltafix EP should be removed from tools and equipment with solvent (Xylem) immediately after use. Cured material can be removed mechanically, or with weak acid.
TECHNICAL DATA
The following typical results were obtained at temperature of 300C
Density A (Enamel) = 1.70 g/ml
B (Hardener) = 1.70 g/ml
Mix Density = 1.70 g/ml
Sagging : Not Sagging in 15 mm thick
Shrinkage : No Shrinkage
Setting Time : Typically 1 hours
Pot Life : 25 minutes
Mechanical / Physical Properties
Compressive Strength (7 days curing time) | 55-65 N/mm2 |
Flexural Strength (7 days curing time) | 30-40 N/mm2 |
Tensile Strength (7 days curing time) | 18-25 N/mm2 |
Bond Strength (1 day curing time) | Failure at concrete |
Packaging | 6 kg set ( A + B ) |
HEALTH AND SAFETY
Deltafix EP contains epoxy resin which can be irritant to the skin. During use avoid contact with the skin or eyes. Wear suitable protective clothing – eye protection, gloves and respiratory equipment, particularly in confined spaces. In case of contact with the skin, rinse with plenty of clean water, then cleanse thoroughly with soap and water. In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice. If swallowed seek medical attention immediately.
FIRE
Deltafix EP is non-flammable materials.