High Performance Solvent Free Epoxy Resin Self - Leveling

DESCRIPTION
Deltafloor SL500 is a two – component solvent free epoxy resin self – leveling that suitable for top coat of epoxy resin flooring system. The cured film of Deltafloor SL500 forms a hard and smooth layer at thickness 500 micron with excellent adhesion to concrete substrate. The product is available in a wide range of standard colors and also provided to ensure the customer need.
 
USES
Deltafloor SL500 is recommended to areas where chemical resistance and aesthetic aspects are required. Deltafloor SL500 is recommended for use in floor of warehouse, industrial and food processing areas, kitchen, laboratory, engineering workshops, and car parks.

ADVANTAGES
Provides a seamless and jointless surface, easy to clean and maintain, hygienic, chemical resistance, excellent wear and abrasion resistance and have aesthetic state of art.

CONSUMPTION
Deltafloor SL500 consumption is 0.8 – 1 kg/m2 for 500 micron thickness. Please kindly contact DELTACRETE to have appropriate technical assistance for the recommended thickness since material performance may vary at different surface.

INSTRUCTION FOR USE
For best performance of Deltafloor SL500, please kindly follow our recommendation. Preparation is a must before application. For new concrete, allow the concrete to cure at least 28 days. Humidity is not more than 75% measured in accordance with BS 8203. Since Deltafloor SL500 is relatively thin coating, the substrate must be fine textured. Any surface irregularities may show through causing excessive wear on high spots. Concrete substrate must be structurally sound, clean, dry and free from all traces of loose material, laitance, oil and grease. Any unsound material must be removed before application. Preparation by captive blasting or diamond grinding is ideal for surface preparation. Priming using Deltaprime Series will enhance the adhesion of top coat with the concrete. The two component of Deltafloor SL500 by captive blasting or diamond grinding is ideal for surface preparation. Priming using Deltaprime Series will enhance the adhesion of top coat with the concrete. The two component of Deltafloor SL500 (component A and B) should be stirred individually before mixed together. Put both component in a mixing vessel and mix them thoroughly using low speed drill and mixing paddle mixer. Continue mixing process until a consistence homogeneous mixture achieved, normally it needed 3 – 5 minutes. Apply the mixed Deltafloor SL500 onto prepared surface using a brush or roller. Ensure that the area is completely coated and that ‘ponding’ material does not occur. Apply the second coat as soon as the first coat is initially dried (typically 5 – 6 hours).

CLEANING
Tools and equipment should be cleaned immediately after use, while the mixture are still un – cured with solvent cleaner. When mixture already harden, please kindly remove the material mechanically.

CURING TIME (at 30⁰ C)

TECHNICAL DATA

 
LIMITATIONS
Deltafloor SL500 should not applied on the surface known to, or likely to suffer from, rising dampness, potential osmosis problems or have a relative humidity greater than 75%. If movement or cracking of the substrate takes place after application then reflective cracking of topping may occur. Ambient temperature when application is more than 10⁰C.

HEALTH AND SAFETY
Deltafloor range of products can cause skin irritations in persons with sensitive skin. Protective clothing like gloves, goggles and respiratory equipment, particularly in confined spaces. Ensure adequate ventilation and avoid inhalation of vapors. If splashed into the eyes, nose, mouth or throat, flush immediately with plenty of clean, warm water and seek medical attention without delay.  

FIRE
Deltafloor SL500 is non – flammable material.